Reference: UH8
The Heatmiser UH8 is designed to work with our 4 channel 230v time clock (TM4) and 230v Set back thermostat (DS-SB) but equally could be used with any 230v room thermostat.
Free Shipping on all orders over £350
50 Guarantee on Pert-al-Pert Pipe
SAME DAY CAD DESIGN SERVICE
The Heatmiser UH8 is designed to work with our 4 channel 230v time clock (TM4) and 230v Set back thermostat (DS-SB) but equally could be used with any 230v room thermostat.
Up to 8 zones can be controlled from the UH8. On board the UH8 are two heating time channels, each zone allows you to specify which time channel it should follow. 2 additional time channel connections are provided for hot water control or other auxiliary devices. On demand from any zone, a 230v output is provided to switch the relevant zone actuator, underfloor heating pump and valve. A volt free connection is supplied for the boiler, making it compatible with almost all types of boilers.
A simple slide switch makes zone 8 suitable for controlling a radiator zone. When used for controlling radiators, zone 8 does not enable the underfloor heating pump, valve and boiler.Up to 4 actuators can be connected to each zone.
Dimensions (HxWxD) 384x148x60mm
The Heatmiser UH8 is designed to work with our 4 channel 230v time clock (TM4) and 230v Set back thermostat (DS-SB) but equally could be used with any 230v room thermostat.
The UH8-N is designed to be used in conjunction with our 12v network thermostats.
The Heatmiser UH4 can be used in conjunction with our mains thermostats. The UH4 is also ideally suited for underfloor heating.
230 volt actuator 2 wire/normally closed. Fits majority of manifolds thanks to the M30 thread and 5mm of maximum travel.
The Heatmiser UH8-RF is our 8 Zone wireless wiring centre designed to work with our Slimline-RF and Touch-RF wireless thermostats.
